Set up on the belay rope of a rescue system that uses two ropes; when a jammed Prusik or a belay device that has locked is holding the load, it lets the load be paid out under control and passed back to the main rope.
HardNo ABoK numberSearch and rescue
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
Near one end of roughly 10 m of 8 mm static cord, form a figure-eight loop with a bight, then clip the loop onto the spine side of the locking carabiner at the load.
Run the cord up through the anchor carabiner, down through the load carabiner, and then return it upward to the anchor carabiner, so that three parts of cord link the two carabiners.
On the anchor carabiner, on the side where its gate is, put on a Munter hitch; Wikipedia requires the hitch to sit in its release position.
Form a bight in the free end and with it make a half hitch that takes in every strand just under the Munter hitch.
Using that bight again, add an overhand knot around all the strands as a backup to the half hitch.
When the load has to be released, untie these two backup knots and let the cord out through the Munter hitch, controlling it by hand.
In rescue systems with two ropes, handing a load caught on the belay rope back to the main rope under control; also freeing a lowering device or Prusiks that have locked up, and getting a knot past the system.
When
It grew out of a comparison of release devices made between 1997 and 1999 (Wikipedia).
Who devised it
Kirk Mauthner.
Where the name comes from
Named after Radium Hot Springs, near where Mauthner lives.
Its story
Kirk Mauthner devised the radium release hitch; according to Wikipedia, it grew out of a broad comparison of release devices made between 1997 and 1999, and it takes its name from Radium Hot Springs, near where Mauthner lives. Rescue teams set it up before work starts, at the anchor of the belay rope in rescue systems that use two ropes: Animated Knots explains that when a Prusik jams or the belay rope's automatic stop catches, the rig lets the weight held by the belay rope be paid out under control and handed back to the main rope. Wikipedia says the rig gives a 3:1 mechanical advantage and is normally made from two locking carabiners and about 10 m of 8 mm cord; Animated Knots also speaks of roughly 10 m of 8 mm static cord, kept ready in a pouch.
Where a long lower is needed: the 3:1 rig eats up rope quickly and, according to Animated Knots, can let the load down only about three metres.
Weakness
It is a rig made of several knots, and it only works if the Munter hitch is set in its release position and the backup knots take in every strand; it is a life-safety system, and this app does not replace hands-on training.