Tie a loose overhand knot about 25 cm (10 in) from the end of the line.
Pass the working end through the eye of the hook or lure, then return it through the overhand knot.
Wrap the working end around the standing part four or five times; very light line needs more wraps and heavy line fewer (chart in the notes).
Pass the working end through the overhand knot once more, going in on the same side it came out of before.
Set the size of the loop while the wraps are still loose; it cannot be changed once the knot is tight.
Wet the knot and ease the wraps together by drawing slowly on the working end; then draw loop and standing part apart until the knot seats, and trim the end.
A fixed loop that does not grip the lure and keeps most of the line's strength, so the lure or fly can swing freely and naturally.
When
Unknown; no date appears in the sources. Kreh published it in Practical Fishing Knots, written with Mark Sosin.
Who devised it
Lefty Kreh developed it (Animated Knots); this page of that site says he built on the Homer Rhodes loop, in which the tail goes around the standing line only once, while its Rapala Knot page names the original Rapala knot as his starting point.
Where the name comes from
It is a loop that does not slip; after its developer it is also called the Kreh loop or Lefty Kreh's Loop Knot.
Its story
This loop carries the name of Lefty Kreh, the American fly fisherman whom Knots 3D ranks as an early leader in taking fly fishing to salt water. According to Animated Knots, Kreh was testing loops in search of a strong one; he took the older Homer Rhodes loop, where the tail goes around the standing line only once, strengthened it with extra wraps, and put the result in Practical Fishing Knots, the book he wrote with Mark Sosin. Kreh found that the line sometimes parted before the knot, and because the tail ends up pointing toward the hook it picks up less weed on the retrieve.