Joins two cords, or a cord to a strap, quickly; it does not jam under load and unties easily afterwards, and the same structure can also be tied as a loop or a binding knot.
MediumABoK 1224Loads and everyday jobsCamping and scouting
Make a bight in the end of the first rope, with the short working end lying beside the standing part and pointing the same way.
Bring the working end of the second rope from the closed end of the bight and take it into the bight OVER the rope close to the closed end.
Cross the end diagonally through the bight and out OVER the leg that carries the short end.
Take the end round the back of both legs on the open side of the bight: UNDER this leg first, then UNDER the other leg (the standing part of the first rope).
Bring the end to the front and cross it diagonally OVER the standing part of the first rope, then OVER its own standing part.
Pass the end out UNDER the closed end of the bight; both short ends must finish on one side of the knot.
Pull both standing parts and both short ends to tighten; the load goes on the two standing parts.
Joining two cords, or a cord to a strap, quickly, holding under load without jamming and untying easily afterwards; in Lapland, tying reindeer harness to sledges.
When
Unknown; the earliest written record known is from 1892 (Max von der Borne, slipped form).
Who devised it
Unknown; the sources describe it as a knot used by many native peoples.
Where the name comes from
Robert Pont found the name 'false sheet bend' belittling and suggested 'reversed sheet bend' or a name taken from Lapland, where he had seen the knot; Wikipedia and Knots 3D trace the name to its use in Lapland for tying reindeer to sledges.
Its story
The Lapp knot shares its core structure with the sheet bend, but the load is taken on the other pair of ends. In a letter in the spring 1996 issue of the IGKT's Knotting Matters, the French knotter Robert Pont traced its history: Max von der Borne shows the slipped form in 1892, Lehman calls it 'Falscher Weberknoten' (German for 'false weaver's knot') in 1907, Graumont and Hensel use the name 'English bowline' in 1939, Charles Warner calls the slipped form the 'girdle knot' in 1992, and Ashley shows the slipped form, without a name, as #1224. Pont writes that he saw it in use in Lapland, in the hide harness the Saami use to hitch reindeer to their sledges and in the leather tongue that hangs a knife sheath, and that North American Indians used it too; according to Pieter van de Griend it is also used by the Maasai, Australian Aborigines and peoples of the Indonesian archipelago. Pont found the name 'false sheet bend' belittling, both to the knot and to the peoples who tie it; he suggested 'reversed sheet bend' instead, or a name taken from Lapland, where he had seen it, and in his letter he calls it the 'Lap knot'. Arborists call the slipped form the 'quick hitch'.
Other English names: Lap knot, Lap bend, Lapp bend, quick hitch
No sourced Turkish name yet.
Where not to use it
In connections where lives depend on it; Knots 3D recommends it for non-critical jobs where convenience matters.
Weakness
If the two short ends come out on opposite sides of the knot it becomes much weaker and slips; tied as a loop and loaded before it is properly tightened, it can capsize.