Fastens a single-strand steel wire leader to a hook, swivel or lure, or forms a lasting eye at its end; big-game anglers rate it the strongest way to attach wire.
Run the wire's end through the hook, lure or swivel eye and leave enough tail for the twists and wraps.
Hold the eye between thumb and forefinger, or in pliers, and lay one wire strand across UNDER the other.
Twist both strands together simultaneously, keeping them crossing at more than 90 degrees; NetKnots asks for at least three and a half twists, Salt Water Sportsman for five even ones.
Bring the working end to a right angle with the standing part and lay about five tight, touching wraps around the standing part.
Bend the working end into a small crank and either rock it back and forth (NetKnots) or swing it round past the standing part like a reel handle (Salt Water Sportsman) until the wire snaps off at the last wrap; do not cut it with pliers.
Fastening a single-strand steel wire leader to a hook, swivel or lure, or forming an eye at its end, so that toothy fish cannot bite through the leader.
When
Unknown; no date appears in the sources.
Who devised it
Unknown.
Its story
Say you are rigging for a sharp-toothed fish offshore and mono will not stand up to those teeth. You make the leader from single-strand steel wire, pass its end through the hook eye and twist it around itself, which gives the wire a firm eye. You do not snip off the spare wire with pliers: you bend it into a little crank and turn it until it snaps off, leaving no burr to cut your hand.
In fishing line or rope; the sources describe it only for single-strand steel wire.
Weakness
If the two strands are not twisted together at a wide enough angle, one simply coils around the other and it fails; cutting the spare wire with pliers leaves a sharp burr.