To tie a horse's halter rope to a ring in its stall with a definite knot that does not slip once well set, instead of a haphazard slip knot.
When
Unknown; the name appears in publications dated 1920 (Smith, Saskatchewan) and 1921 (Dana and Pearl, Washington).
Who devised it
Unknown.
Where the name comes from
The sources describe it as a knot for tying the halter rope; Smith writes that some people know the same knot as the 'Scotch plowman's knot'.
Its story
The halter tie, a knot for fastening a horse's halter rope to a ring in its stall, is described in two rope and knot guides published in Canada and the United States in the early 1920s. J. Macgregor Smith's pamphlet 'Rope Knots and Hitches', published by the Saskatchewan Department of Agriculture (1920 according to the archive.org record), regrets that most people tether a horse with no particular method, pointing to the many slip knots in stables and the tie lines wound low around hitching posts in the street, and shows this knot in four drawings; it adds that some readers may know it as the knot a Scottish ploughman used to fasten rope reins to a horse's bit ('Scotch plowman's knot'). In a Washington State College bulletin dated December 1921, Dana and Pearl write that some people favour it for securing a halter rope in a stable stall, that it holds when well set, and that in some cases it can replace what they call the underhand bowline. Both sources say it must never be put round a horse's neck, because a wrongly made tie turns into a slip knot; Dana and Pearl add that this could strangle the animal.
Around a horse's neck: a halter tie that is set wrongly turns into a slip knot and can strangle the animal.
Weakness
It must be set by pulling the short end first; pulling the long rope before that straightens its twists and leaves only two half hitches round the standing part, which run like a slip knot.