Bend
Water knot
Turkish: Perlon düğümü
Joins the ends of flat webbing (tape).
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- A loose overhand knot is tied in the end of the first tape. Lay the end of the second tape beside the first end where it leaves the knot and feed it in: OVER the arc of the loop.
- Follow the first tape's path backwards, always on the same side: pass UNDER the standing part.
- Turn along the lower edge of the loop and pass OVER the standing part.
- Go round beside the arc of the loop: pass UNDER both ends.
- Come down beside the first standing part: OVER two strands, UNDER two. The end comes out beside the first standing part; the tapes stay side by side and never cross.
- Leave tails at least a hand long; pull all four strands to dress the knot and set it hard.
The method was checked against: Wikipedia: Water knot, AFAD, "İpli Kurtarma Hazırlayıcı Eğitimi" (2025), s. 14, Şekil 1.16.
Turkish names, by who uses them
- Climbers: Perlon düğümü
- General use: Bant düğümü
Other English names: Tape knot, Ring bend, Grass knot, Overhand follow through, overhand follow-through
Main Turkish name from climbers · AUZEF Dağcılık
- Where not to use it
- In round rope, where other bends work better.
- Weakness
- The tails slowly creep back as load comes and goes; leave long tails and check it before every use.
Similar and alternative knots
Sources and verification
- Wikipedia: Water knot
- Wikidata: Q647152
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.