Yosemite bowline TR

Loop

Yosemite bowline

Wraps the tail back through to reduce the bowline's tendency to loosen when unloaded.

Medium No ABoK number Climbing

Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.

How to tie it

  1. First tie a bowline. Make a small loop in the standing part: take the working end round to the right and OVER the standing part.
  2. Leave enough for the eye and a long tail: take the end down OVER the bar (ring), back UNDER it and up below the loop.
  3. Bring the end UP through the loop from underneath.
  4. Take the end around BEHIND (under) the standing part.
  5. Bring the end back DOWN through the loop: the bowline is done and the tail lies inside the eye.
  6. Yosemite finish: take the tail out round the FRONT of (OVER) the adjacent leg of the eye and back in BEHIND (UNDER) it.
  7. Feed the tail up along the standing part: UNDER the loop, UNDER its own way down, UNDER the crossing, and OVER the collar round the standing part; it comes out beside the standing part.
  8. First pull the standing part against the eye to set the bowline, then pull the tail. Leave a long tail.

The method was checked against: Wikipedia: Yosemite bowline, Knots 3D: Yosemite Bowline.

No sourced Turkish name yet.

Where not to use it
On its own as a life-safety tie-in without training.
Weakness
Tied wrong it can turn out worse than a plain bowline.

Similar and alternative knots

Sources and verification