Bend
Racking bend
Joins ropes of very different size by racking the thin rope in zigzag turns around a bight of the thick one.
How to tie it
- The thick rope lies as a bight: short end on the left, standing part on the right. Bring the thin line OVER the end of the bight into it.
- Start the figure-of-eight racking: take the thin line UNDER the left leg, round it and back OVER it.
- Cross diagonally up between the legs; UNDER the right leg, round it and back OVER it.
- Keep racking upwards: UNDER and OVER the left leg, UNDER and OVER the right leg, and once more. Tighten each turn; at least four complete turns.
- Make the last turn round the left leg: UNDER, OVER; then go UNDER the right leg (the standing part), round it downwards and back OVER it. That is four complete turns.
- Finish with a half hitch: take the end OVER the left leg and out UNDER the arc of the last turn.
- Snug the turns down and pull both standing parts to tighten.
The method was checked against: NetKnots: Racking Bend, Wikipedia: Racking bend.
No sourced Turkish name yet.
- Where not to use it
- Where a quick join is needed.
- Weakness
- Slips if the turns are not made tight.
Similar and alternative knots
Sources and verification
- Wikipedia: Racking bend
- Wikidata: Q7279798
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.