
Hitch · Slipped
Mooring hitch
Ties a boat temporarily to a bollard or ring; pulling the end releases it at once.
How to tie it
- Take the rope OVER the post and back BEHIND (under) it; bring the tail down beside the standing part.
- Make a loop lying OVER the standing part: take the tail OVER the standing part to the left, round and up, and back OVER it to the right.
- Lead the tail out UNDER its own part.
- Take a bight of the tail ACROSS (over) the loop and tuck it sideways UNDER the standing part; the end stays out on the right.
- Pull the standing part to set the hitch; pull the tail to release it.
The method was checked against: Animated Knots: Mooring Hitch, Wikipedia: Mooring hitch.
No sourced Turkish name yet.
- Where not to use it
- In moorings left unattended for long.
- Weakness
- Opens if the end is pulled by accident.
Similar and alternative knots
Sources and verification
- Wikipedia: Mooring hitch
- Wikidata: Q6908409
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.