
Bend
Hunter's bend
Joins two ropes with two interlocked overhand knots.
How to tie it
- The other rope lies as a loop, its end crossing OVER its standing part and pointing up. Make a loop in your rope and link it with the other loop: OVER it at the top, UNDER it at the bottom.
- Bring your end up UNDER its own standing part: both loops now have the same handedness.
- Curl the end round and tuck it through the middle of both loops: in OVER your standing part and the edge of the other loop, out UNDER the other loop and your own.
- Do the same with the other end, mirrored: in UNDER the top of its own loop and the other loop, turn in the middle and out OVER the other loop and the bottom of its own.
- Pull the ends and the standing parts in turn to tighten; the two overhand knots lock together.
The method was checked against: Animated Knots: Hunter's Bend, Wikipedia: Hunter's bend.
Other English names: Rigger's bend
No sourced Turkish name yet.
- Where not to use it
- On its own where it cannot be checked often under load.
- Weakness
- Can slip in slippery synthetic rope.
Similar and alternative knots
Sources and verification
- Wikipedia: Hunter's bend
- Wikidata: Q2027925
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.