Autoblock (French prusik) TR

Friction hitch

Autoblock (French prusik)

Placed below the belay device when abseiling, it gives a backup lock if your hand slips.

Easy No ABoK number Climbing

Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.

How to tie it

  1. The loop is traced as one strand; the carabiner is shown as a bar. One leg of the lower end (B) is laid passing BEHIND the carabiner and going up.
  2. Wrap the loop round the main rope (the abseil ropes) four times from the bottom up: OVER (in front), UNDER (behind)… Leave room between the wraps for the second leg.
  3. Bring the upper end (A) down and clip it into the carabiner: in FRONT of it and back out BEHIND (under) it.
  4. Bring the second leg back down beside the same wraps: UNDER, OVER… The loop is wrapped double; the wraps must not cross each other.
  5. Clip the lower end (B) into the same carabiner too: down in FRONT of it. Both ends are in the carabiner; lock it to the leg loop.
  6. Weight the harness to test: it must hold and slide when pushed down by hand. Keep it clear of the descender.

The method was checked against: NetKnots: Autoblock Knot, Wikipedia: Klemheist knot.

No sourced Turkish name yet.

Where not to use it
As the main load-holding device.
Weakness
Too few wraps and it slips, too many and it sticks; it has to be tuned.

Similar and alternative knots

Sources and verification

  • The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.