Overhand loop TR

Overhand loop: How to tie it

The animation and practice area on this page need JavaScript. The steps are written out below.

Steps

  1. Leave a long tail and make a loop: bring the working end OVER the standing part. (When tied in the bight, the doubled rope does this.)
  2. Tuck the end UNDER the standing part into the loop.
  3. Bring the end out OVER the top of the loop: a loose overhand knot.
  4. Take the end OVER the bar (ring, karabiner) and back UNDER it: this is the eye.
  5. Feed the end back into the knot where it came out and follow the first path in reverse, alongside it: OVER the top edge, UNDER the standing part.
  6. Keep following: OVER the standing part.
  7. Go round the loop and UNDER both strands.
  8. Go down beside the standing part: OVER two strands, then UNDER two.
  9. Pull the eye and both strands to tighten; the strands should lie side by side.

Back to the knot page