Bowline on a bight TR

Bowline on a bight: How to tie it

The animation and practice area on this page need JavaScript. The steps are written out below.

Steps

  1. Take a long bight in the middle of the rope and, with the doubled rope, make a small loop in the standing part: the bight crosses OVER it. (The animation draws the two strands of the bight one at a time: first one, and at the end the other back along the same path.)
  2. Leave enough for the eyes: take the bight down, round, and back up below the loop.
  3. Push the end of the bight UP through the loop from underneath: UNDER its lower edge, OVER its upper edge. A double eye stays below.
  4. Open the end of the bight, pass it down over the whole knot and both eyes, and bring it up behind: the bight settles round both standing parts like a collar, its upper side UNDER (behind) them, its lower side OVER them.
  5. The other strand of the bight always lies beside the first: it goes down through the loop (OVER its upper edge, UNDER its lower edge) and forms the inner eye.
  6. The other strand doubles the loop too: OVER the standing part, UNDER the two strands through the loop, then OVER them.
  7. The other strand leaves as the second standing part: UNDER both loops and the lower side of the collar, OVER its upper side.
  8. Pull the eyes against both standing parts to set the knot; the two eyes can be adjusted to different sizes.

Back to the knot page