Hitch
Trucker's hitch
Turkish label on Wikipedia (not verified): Kamyoncu bağı
Gives the rope a pulley effect to tie loads down very tight; for loads on vehicles and tent guys.
How to tie it
- The rope is tied to a fixed point above. Make a loop in the middle of the rope: it crosses OVER its own standing part.
- Take a bight from the slack (working) side and pull it through the loop: in UNDER the edge, out OVER the bottom edge. The bight hangs below as the eye (a slipped half hitch).
- Take the end round the hook (the fixed point) below: down OVER (in front of) it and back up UNDER (behind) it.
- Pass the end through the eye above: OVER one side and UNDER the other.
- Using the eye as a pulley, pull the end down to tension the rope.
- Holding the tension, tie the end round both lines with two half hitches: OVER both, UNDER both, OVER its own part; then once more the same way and out UNDER the diagonal.
- Snug the half hitches down. To release, undo the half hitches first.
The method was checked against: Animated Knots: Trucker's Hitch, Wikipedia: Trucker's hitch.
Other English names: dolly knot, Wakos transport knot, lorry driver's hitch, harvester's hitch, hay knot, sheepshank cinch
No sourced Turkish name yet.
- Where not to use it
- For long periods when chafe matters, since the rope rubs over itself.
- Weakness
- The rope rubs on itself, heats up and wears.
Similar and alternative knots
Sources and verification
- Wikipedia: Trucker's hitch
- Wikidata: Q636005
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.