
Binding · Lashing
Transom knot
Quickly ties two crossing sticks together.
How to tie it
- Bring the standing part up: OVER the crossbar, then OVER (in front of) the upright to the right.
- First turn: above the crossbar, take the end BEHIND (under) the upright from right to left.
- Bring the end diagonally down from top left to bottom right: OVER the standing part, the upright and the crossbar.
- Second turn: below the crossbar, take the end BEHIND the upright from right to left; it also passes UNDER the standing part.
- Take the end OVER the standing part to the right and turn it upwards, OVER the upright.
- Tuck the end upwards: UNDER the diagonal, OVER the crossbar, UNDER the front leg of the upper turn, then OVER the back leg and the upright and out. Both ends now come out between the two turns.
- Pull the end and the standing part to tighten.
The method was checked against: NetKnots: Transom Knot, Wikipedia: Transom knot.
No sourced Turkish name yet.
- Where not to use it
- As a permanent binding in load-bearing structures.
- Weakness
- Hard to undo without cutting.
Similar and alternative knots
Sources and verification
- Wikipedia: Transom knot
- Wikidata: Q7834746
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.