Dropper loop TR

Loop

Dropper loop

Makes a loop that stands out from the middle of a fishing line, for attaching an extra hook.

Medium No ABoK number Fishing

How to tie it

  1. This loop is tied in the middle of the line: make a loop, turn one side of it round the crossing 5–6 times (each turn adds one wrap on each side) and pass the bottom of the loop through the opening in the middle. Here we trace the line's path from one end, with five wraps on each side. The line from the left curls up in the middle (top of the ring), then comes down and wraps round the line on the right.
  2. Turn at the bottom right and bring the loop up OVER the top of the ring; at the top go OVER the bar (dropper ring), back UNDER it and come down with the other leg (again OVER the top of the ring).
  3. Turn at the bottom left and make five wraps round the left-hand line: each turn once OVER, once UNDER it; on the last turn the end goes down UNDER the line.
  4. Draw the bottom of the ring: OVER both legs of the loop, then rise on the right and run through the wraps as the right-hand line.
  5. Wet it; holding the loop, pull both ends of the line slowly: the turns gather evenly on both sides and the loop stands out at right angles.

The method was checked against: Animated Knots: Dropper Loop, Wikipedia: Dropper loop, NetKnots: Dropper Loop.

No sourced Turkish name yet.

Where not to use it
For lifting loads.
Weakness
With too few turns the loop will not stand straight.

Similar and alternative knots

Sources and verification