Binding
Boa knot
Turkish label on Wikipedia (not verified): Boa bağı
Binds cylindrical loads very tightly in a way that holds even when cut.
How to tie it
- Take the end OVER the rod and back UNDER it; lay a second turn beside it the same way (two loops).
- Cross the end diagonally OVER the standing part to the other side: the loops are twisted into a figure eight.
- Make two more turns on the other side: OVER the rod, back UNDER, and once more beside it.
- Bring the end back OVER the turns and the standing part, then tuck it UNDER the standing part and the diagonal; the ends come out in the middle.
- Pull the ends away from the object, dress the strands and tighten until the turns grip it firmly.
The method was checked against: Wikipedia: Boa knot, The Christian Science Monitor (9 Haziran 1998).
No sourced Turkish name yet.
- Where not to use it
- Where it has to be untied.
- Weakness
- Complicated to tie.
Similar and alternative knots
Sources and verification
- Wikipedia: Boa knot
- Wikidata: Q3524727
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.